Help done a 3” lift how the fook do you get the black bit off gear stick can get it out of the gearbox but can not get the black bit off just keeps turning

what black bit

the fat bit?

Bild entfernt (keine Rechte) am I right in saying it need bent so need to get it off

Yes mate

Or does it stay on and just bend the bottom

Pull the rubber off it is bolted in 4 for gear stick 3 for transfer

Pull the rubber off it is bolted in 4 for gear stick 3 for transfer

Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)
Cheers there was a c clip on the bottom got it all in bits but run out of time will take it bits again tomorrow and bend it

Bild entfernt (keine Rechte)

cut that bit out it will cause u grief

nice love your work mate

I cut and bent them on truck 1 but far easier making a middle bit to fit

what is that blue hose you have coming out for in the pic

they are the extended breathers for the 2 boxes

Got the 3” lift kit done had 2” lift kit before so all the pipes hose have been done b4 got in the truck started it what a noise bloody fan so grinder out to sort that 🤣😂Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)Bild entfernt (keine Rechte)

sticks?

should have made this a new post

no what did u do to them

got them red-hot with gas axe mate and give them a good tw*< with a 2lbs hammer ; ))

ha ha that works did the rubber inside melt at all

no mate got a wet rag wrapped it over the rubbers used a very fine torch and just heated the kick/bend on the gear/diff stick used oxy-acetylene and then put it in some water fast

sweet as long as it works that is a result

will get some pic up of how much it needs to be bent and it is a lot

oh i know and not in 1 direction either, and dont mention bending the transfer stick!