hi all
New to the forum scene but got a bit of a headscratcher issue
So looking for any pointers that may guide me towards solving my issues
I was removing offside front abs sensor on a 2009 l200 for the purpose of removing hub to change bearing i damaged sensor so after job done i replaced with new
But i made mistake off starting vehicle to move it off ramp while i was waiting on new sensor arriving next day the abs module has stored the fault code saying front right sensor short or open circuit after replacing new sensor light still on wont clear code i have done live data whilst driving and all four sensors are displaying the same speed so everything working but just cant get code to clear i am using the snap on ethos
Ive tried battery disconnect and while engine running all to no avail the abs light doesnt even flicker during code erase just stays on solid i have had on previous occasions when you clear codes light goes out and comes straight back on but not on this
Any ideas would be much appreciated
Thanks in advance for any advice