Mite get the discs done when I do the pads then. They have been on for over 100'000. Time for a change. I've got top and bottom bj's to do so it will be easier to do them with everything off.
Do you have Bj spacers on yours for your lift??

yes you may as well do it all in one hit, the discs are cheap enough any way not to really,

no BJ spacers on my one no, did think about flipping them over though

I've got the Bj spacers on mine with the bj's flipped over. Only prob is that it chews thru the drivers side inner cv boot a lot. I was goin to put some free wheel hubs on to stop this happening. I wondered if that's why you had put them on yours

I put them on to prolong the life of all the components bearings rubber drive shafts
I think I wont bother flipping them then the chewing probably happens off road as the mowvement twisting and turning is much greater

I'm hopefully goin to get the front diff holder plates of stormys truck so I can look at them and make some more that drop the front diff by 2" to align everything back up.

that will be interesting to see, wont they need to be longer too?

Yes. I will have to get fresh steel. Re bend it and cut the holes. And il also have to move the stud holes round slightly to adjust the diff up to keep the prop lined up. Need to do some calculations to get the right angle.

sounds like hard work!


I have just finished the other side going out for a test drive after lunch.

its a record for me parts arrive on a friday and get fitted by noon the next day

Bet the winch is on the garage floor 😁

you know what it would not even fit in the garage

Would look better on Tony's truck anyway. Lol

Saying that though i have two in my garage I wonder how much I could get for them??

I will have another one!

I have to agree with hound dog would look the muts nuts on my truck

LOL it aint happening

greased the whole truck up had to wrestle with one of me shaft nipples.

also wd-40'd all of the bolts for when I do the lift and all of the tow bar bolts and the winch tray bolts for when I fit the winch.

started to fit the snorkle today all holes drilled and painted just need to order a silicon hose on a 45 deg for the snorkle to apollo as I only want to do the job once.

Oh and I need to clean the apollo it is fecking filthy

looking good so far cheffy.........

Thanks gotta clear out the garage!

I also fitted new washer jets fan mist stylie ones

Quote: 123hotchef wrote in post #145

---

I also fitted new washer jets fan mist stylie ones

---

Ebay mate

old washer jets

new washer jets

they do look bigger and bulkier but they wash the screen much better will use less water too me thinks.


next mod on the list get bigger battery and get a smaller washer bottle so the batter will fit